1. Home
  2. Docs
  3. SNAM6000 3D print 4 dof remote control robotic arm manual
  4. 1. Connect all circuits to test
  5. 1.2 connection line

1.2 connection line

1.2.1 Connect the joystick

The joystick access area is shown in the figure (red frame)

Note:
VRy, VRx connected to line S;
Connect the SW of the left and right sticks to (S, 2) and (S, 4)

1.2.2 Connect small lights

The small lamp with a resistor is positive. Positive connection (S, 3) and negative connection (G, 3) as shown in the yellow box area

Was this article helpful to you? Yes No

Leave A Comment