1. Home
  2. Docs
  3. SNAM6000 3D print 4 dof remote control robotic arm manual
  4. 1. Connect all circuits to test
  5. 1.4 test the servos

1.4 test the servos

After connecting the line, you can start the machine. Use two rocker to control up, down, left and right to test whether the servo works normally.

Note:

If one servo fails to work normally, please check whether the line is connected wrongly;

If all servo fail to work normally, please check the power supply or download the program again. (see the source code for the program)

Was this article helpful to you? Yes No

Leave A Comment