- The steering gear is not moving or is not controlled
The power supply may be insufficient, or the wiring may be faulty. You can replace the power supply or re-plug the cable
2.Claws are stuck or not tight
The main reason for this is that after the power is turned on, the rudder will automatically move beyond its corresponding position, and its corresponding position is just the physical dead angle of the mechanical arm. At this time, a situation occurs in the servo: it wants to The position is moving, but the part is blocked, and it has reached the extreme point of movement. The steering gear is stuck.
How to solve it? First, disconnect the steering gear from the rocker arm, then power on, control the steering gear to rotate to the end of one end, then move the corresponding part of the mechanical arm to the corresponding maximum position, and then install the steering gear. At this time, the steering gear can follow The knob is controlled.
Note: If the claws are stuck, it will cause the steering gear to heat up, and in severe cases will damage the steering gear.