Description

Product Introduction:
This is a horizontal mechanical clamp driven by a small nail hammer MG90S servo, and the bracket is 3D printed.
Product Features:
Horizontal clamping, the center of the clamp does not shift during the clamping process
Installation hole compatible with open-source 20factory robotic arm
3D printing
Assemble by oneself
No design drawings available
Technical parameters:
Weight: 26g
Maximum mouth opening: 21mm
Clip finger thickness: 13mm
Operating voltage of servo motor: 5-6V
Servo model: Small Hammer MG90S
Reaction speed: 0.11 seconds/60 degrees (4.8V)
Operating temperature: 0 ℃ -55 ℃
Dead zone setting: 5 microseconds
Plug type: DuPont
Rotation angle: maximum 90 degrees
Servo type: digital servo
Usage:
PWM control of mg90s servo motor
The servo has three line definitions:
Dark gray: GND
Red: VCC4.8-6V
Orange yellow line: pulse input